Standard fog lights (PTF) on the Lada are only available in the “Lux” trim levels. If you are the owner of a car with a simpler configuration (“Norma” or “Standard”), then you can install PTF on a sedan, station wagon, hatchback or liftback yourself according to the simplest and most universal scheme..
Preparatory stage (selection of PTF for Lada Granta)
The range of PTFs is not large; it is represented by several domestically produced models. Some owners claim that PTFs from Opel and Ford are compatible, but the information has not been verified.
| Name / manufacturer / article | Price, rub.) |
| LADA Granta (VAZ 2190) / Kalina 2 / LADA Largus OSRAM Kit 21900-3743010 | from 2800 |
| Kit 21900-3743011 | —/— |
| —/— 2190-3743011 | —/— |
| —/— 2190-3743010 | —/— |
| PTF wiring kit for LADA Granta (2190 2874498) | from 600 |
| PTF "LUCH" set 1118-3743010/11 | from 1800 |
| PTF glass (02B08507) Granta / Kalina 2 / Largus, Datsun | from 750 |
| AUTOMOTIVE LIGHTING / BOSCH (982469641) | from 2000 |
*prices are as of September 22, 2018.
Procedure for self-installation of fog lights on a Lada Granta liftback
We place the car on a flat platform with access around the perimeter.
- We dismantle the front bumper along with the radiator grille.
- Using a milling cutter, we cut holes in the openings for the PTF.
- We install the fog lights and secure them to the fasteners.
- We connect the blocks with wires.
- Reinstall the bumper. We check the functionality of the system.
Where to install fog lights?
There are special holes for fog lights on the Grant. Take a close look at the front bumper. In it, at the very bottom, there are stamped seats for installing foglights. On more modern cars, plugs are installed here, which can be easily squeezed out by hand. On early models, you will have to cut holes to mount the headlights. It is not recommended to install standard type fog lights on your car, as they will only spoil the appearance of the car.
Step-by-step process for preparing and installing fog lights
In the auto store we purchase: PTF, corrugation (at least 3.0 m), adapters - adapters for PTF with standard wiring.
- To remove the front bumper, unscrew three self-tapping screws on each side, four plastic clips, three “10” bolts in the lower perimeter;
- We remove the structure along with the radiator grille;
It is important to know!!! In the Norma and Standard models, there is no hole for adjusting the fog lights. The owners independently cut out a diameter of “8”. In the Liftback body modification, the opening is factory-made.
- We cut out the opening for the fog lights along the contour, it is factory-made;
- To make it smooth, treat the surface with a household hairdryer;
- We fix the headlights on three standard mounts;
- We connect adapters to each of the lamps, since the standard block with wires is short, its length is not enough;
- We put on the front bumper, screw it in with bolts and plastic clips.
What you need for installation
Once you have decided on the type and model of headlights, begin the preparatory work. Installing fog lights on a Grant requires a special installation kit for this process. The kit usually includes the necessary wiring (under the hood and into the interior), a relay and a push-button switch. In addition, to install PTF you will also need:
- fasteners for mounting fog lights in a car bumper (six self-tapping screws);
- Fasteners for wiring (various plastic ties, clamps, ring latches, etc.) - it is better to take them with a reserve;
- corrugated tubes for laying wiring (the norm is 6 or 9 cm in diameter);
- crimp terminals:
- insulating tape;
- drill and set of drills;
- countersink for metal, preferably round;
- a stationery knife and several blades for it.
Now you are “fully armed” and can proceed directly to the installation.
Wiring diagram for fog lights Lada Granta liftback
Engine compartment
- We lay an additional wire from the right PTF headlight to the left one. We solder it and bring it into the engine compartment to connect to the relay.
- We fix the mass to the body at the place where the bumper is attached, maybe under the license plate, in the center.
- Do not forget to lay all electrical wiring in a corrugated material made of fireproof material.
Interior of the Lada Granta liftback car
- We lay the corrugated hose through the hole in the hydraulic corrector seal.
- The connection is best made at the ignition switch. That is, when turned off, the headlights will go out automatically.
- Open the glove box lid, press the side stops, and remove the lid.
- We stretch our hand into the cavity and carefully squeeze out the block of two buttons for controlling the heated glass and PTF.
- We power the minus from the heater button. Plus we won’t take it, since they will be activated at the same time.
- We connect the positive cable and install the unit again.
- We connect to the positive from the ignition switch unit (blue wire), it is located under the steering wheel.
- Finally, we power the relay - regulator: ground - wire from the button - end to the PTF - plus to the ignition.
In each specific configuration, the color scheme of the wire may differ. Read the diagram in the instruction manual for details. Classic colors: red, yellow, blue, brown. If you do not want to supply power through the ignition switch, the connection diagram is simplified with one less procedure.
How to install PTF on Granta
To install it yourself, you will need a minimum set of tools and the ability to read electrical diagrams and have minimal knowledge of working with car wiring. For the simplest connection, we will use ready-made PTF connection kits, which are sold in almost any auto store. There is also an option to connect the PTF to a standard location in the light control module, but this will require replacing it with a unit from the “Lux” version, which leads to additional costs.
In addition to wiring for connection, you will also need the headlights themselves; there are now two PTF options on the market for the Lada Grant: produced by Kirzhach and Luch (formerly Bosch). As the author of this article, I recommend the first option, because... it has spherical glass, which better withstands impacts from stones and in general there are no complaints about them, unlike PTF from Luch. In the photo below, on the left is Kirzhach, on the right is Luch.
Necessary kit for connecting PTF to Lada Granta
To install the PTF in the bumper, you will need to remove it. You can read how to do this on our website in the article “Removing the bumper on a Lada Granta”.
After removing the bumper, we will need to cut a hole for the PTF in the stampings on the bumper. On new cars, sometimes there is a plug in this place that is simply squeezed out. If you don’t have one, use a drill and a utility knife as indicated in the photo.
The ground for wiring the PTF can be taken from the bolt on the front panel, they are marked in red in the photo. We bring the wiring itself into the cabin through the standard hole in the left wing, where all the wiring goes into the mounting block. The wiring can also be routed through other seals in the front panel, for example through the gas pedal wiring seal.
The connection is made in the mounting block, completely according to the diagram below.
Connecting according to this scheme will allow you to implement a scheme in which the PTFs will operate only from the ignition, regardless of the operation of the side lights. After installation, if necessary, adjust the PTF light beam so that the fan of light is on the verge of the low beam headlights.
You can discuss this article on our forum in the Electrical Equipment section.
Step-by-step instructions for installing a rear fog light
Many Lada Granta Liftback car owners are surprised to hear about this, but it is a fact. Of course, we are not talking about PTF in its classic form, but about a laser brake light. It is installed in the rear of the car and informs the driver behind about the vehicle. Since there is no strictly defined installation location, it is customary to fix it in the area of the license plate, under the lower contour of the bumper, in the spoiler. There are known cases of embedding an accessory inside.
A bright red light beam informs drivers behind, preventing accidents. The brake light is also used when it is necessary to notify the driver of the need to switch the high beam headlights. An alternative way to use lighting when backing up or parking in conditions of limited visibility. The maximum effective beam length is 25.0 meters. Exceeding the length does not guarantee the quality of lighting.
The voltage is supplied from the left/right brake light. Activation is possible either by pressing the brake pedal or by a separate button. The owner makes the decision based on personal beliefs. In practice, activation occurs with an autonomous button, since when driving backwards it is not always advisable to use the standard brake pedal. It is strictly forbidden to point the laser beam at the windshield area behind the driving driver.
Reviews
| № | Positive |
| 1. | Kirill , 36 years old: after purchasing a Lada Grant from the showroom, I immediately purchased a PTF from OSRAM 21900-3743010. I didn’t install it at the service station because I can do it myself. In general, I am satisfied with the quality of lighting, no complaints. |
| 2. | Vitaly , 29 years old: it is obvious that there are not enough foglights out of the box. I often drive at night and need a good view of the road. Since I don’t understand manufacturers, I entrusted it to a specialist at a service station. PTF Lada Granta liftback - my advice. |
| 3. | Georgiy , 37 years old: I’ve been working as a taxi driver for the second year, my shift often ends after one in the morning. The disadvantage of the standard lighting system is obvious. I bought a “LUCH” set 1118-3743010/11 at the market. The cost is 1850 rubles, the quality is good, installation couldn’t be simpler. |
| 4. | Victor , 25 years old: I work as an entrepreneur, purchasing goods from hundreds of kilometers away. By morning the products should be on the counter. To help the standard headlights, I installed PTF. Second week, no complaints. |
| 5. | Maxim , 28 years old: I leave my positive review of BOSCH fog lights (982469641). Special thanks to the store manager for his practical advice. |
| 6. | Konstantin , 37 years old: during scheduled maintenance, he ordered the service of installing a PTF from a technician. I chose OSRAM 21900-3743010 because the price and quality are at a decent level. Numerous positive reviews. |
| 7. | Vladimir , 48 years old: I was a little upset by the lack of fog lights from the box on the Lada Granta liftback. I had to install it myself last weekend. The lighting is good, no complaints. |
| Negative | |
| 1. | Alexander , 36 years old: not only are fog lights not included in the kit, but they also provide poor lighting. We are talking about a domestic manufacturer. Installed by BOSCH (982469641). I use it myself and recommend it to others. |
| 2. | Vitaly , 39 years old: installed domestic PTF OSRAM 21900-3743010. I regretted buying it, wasted money. The quality is below average, the angle of inclination is several degrees. I don't recommend it. |
| 3. | Vyacheslav , 37 years old: not happy with the installed fog lights, they don’t cover the side of the road, visibility is mediocre, the light is dim. |
Conclusion Every product has its own buyer. If you don’t find fault with a budget car, which is the Lada Granta Liftback, the quality of PTF lighting is good, it is enough for visibility. Of course, when compared with headlights from foreign brands in the premium segment, the advantage of the latter is obvious. In order to increase the service life of accessories, purchase products exclusively from certified points of sale. Require the provision of documents, check the functionality on site.
Which PTF should I put on the Grant?
Today you can find foglights for Lada Granta on sale in two variations - with flat glass or spherical. In this case, the choice of devices depends entirely on the preferences of the car owner. As our compatriots write in their reviews, spherical glass by its design is more durable and strong. Car enthusiasts make such conclusions because it has better resistance to vibrations and impacts from stones. You can find special PTFs for Granta Liftback on sale; they can be installed on this car model, but usually car owners use foglights from Kalina (the author of the video is Vladimir Gennadievich).
